Cute Unicorn (HueForge)

I stopped uploading and updating my models here at Printables!

My actual models can be found on my MakerWorld profile — with print profiles.
Take care to use the newest models ...

In the comments of my Low Poly Unicorn I noticed that your kids love it. So I made a painted unicorn, which is primary for the girls and also a cute tiger for the boys.

You need 4 filaments to print/paint this 2D unicorn: black, red, yellow and white. You just have to swap the filament 3 times, so no AMS or MMU required.

I used Bambu Lab Filament, but other brands will work, too.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Filaments Used:

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Red Transmission Distance: 5

PLA BambuLab Basic Yellow Transmission Distance: 6

PLA BambuLab Basic Jade White Transmission Distance: 4

Swap Instructions:

Start with Black

At layer #9 (0.8mm) swap to Red

At layer #14 (1.2mm) swap to Yellow

At layer #16 (1.36mm) swap to White for the rest.

Generated using the HueForge software! See videos with instructions for filament swaps with Bambu Studio and PrusaSlicer ...

… or try the included .3mf file.