Self-draining kitchen sponge squeezer

If you press-remove water from your sponges, they will dry faster (and will be less yucky).

The hinge attachment is made with a 1.75 mm filament bit.

WARNING: it is trongly advised to print the hinge zone, on the tray, with 100% infill. Otherwise, it may (most probably will) break when you dry-press a sponge, as showh below. You may print the handle zone, on the lid, with the same high infill but the forces there are far lower so it's not mandatory.

I used modifiers in PrusaSlicer, because the tray in itself does not need such infill (10/15% should be far enough). The uploaded 3MF files already have the proper modifiers, on the tray (hinge side) and on the lid (handle side, but I feel it's far less useful there).