Replacement Arm - HOMIDEC Indoor Clothes Dryer

Replacement arm for the HOMIDEC Indoor Clothes Dryer. If one of the pivot arms breaks, this print-in-place replacement avoids discarding the entire dryer.

Modeled from the original broken part with the following key dimensions:

Total length: 260 mm

Width: 22.5 mm (37 mm at shoulder)

Body thickness: 15 mm

3× pivot bosses Ø16.7 mm, 86 mm apart

Oblong slot: 36 × 7.5 mm (through-hole for screw)

Print settings:

Material: PETG or ABS recommended (avoid PLA — humidity & mechanical stress)

Orientation: flat, smooth face down on the bed

Perimeters: 4 minimum

Infill: 40-50%

Supports: not required