Offset bracket for JKSRadio Meshcore / Meshtastic repeat...

I've got one of the 868Mhz Meshcore repeaters with the 5.5db 40cm antenna but it came with a pole mount bracket and I needed wall mount. I've made this wall mounting bracket with an offset to hold it away from the wall and up a bit so that it can get around roof lines and keep the antenna up in clear air.

It's intended to use 3 5mm x 40mm screws and plastic plugs to mount to the wall and to screw to the repeater with the supplied screws. It's got cable-tie mounting points on the arms and is designed to shed water away from the wall to hopefully prevent it causing issues with damp.

You probably will need to use support to get this to print, and since it will be mounted outside for a prolonged period I'd recommend the use of ASA to print it.